迪威網(wǎng)友5839a8
發(fā)布時間：2021/2/15 10:34:00
This is a rework of my original switch panel
Note: updated the shifter lever 3/12/2019 to strengthen it. Added washe to take out slop created by taking 1mm off width. Print 2 washe. Suggest printing of shifter at 100% infill.
Added shift knob
Added clamp base
Added mounting holes for joystick controller
Corrected hole sizes to fit switches better
Parts needed:
8 2x8mm screws
3 3x12mm screws
2 #30 rubber o'rings (from plumbing department of local hardware store)
joystick control (
8 SPDT miniature switches (
2 to 4 miniature push button switches (
2 micro switches (
Note: updated the shifter lever 3/12/2019 to strengthen it. Added washe to take out slop created by taking 1mm off width. Print 2 washe. Suggest printing of shifter at 100% infill.
Added shift knob
Added clamp base
Added mounting holes for joystick controller
Corrected hole sizes to fit switches better
Parts needed:
8 2x8mm screws
3 3x12mm screws
2 #30 rubber o'rings (from plumbing department of local hardware store)
joystick control (
8 SPDT miniature switches (
2 to 4 miniature push button switches (
2 micro switches (
|
共個文件
壓縮包大小：854KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付