迪威網(wǎng)友08f76f
發(fā)布時(shí)間：2021/1/16 23:03:00
This is a fix/remix of TenDutch's Batman Spinner found here:
I found the original tricky to print with ABS due to the slight overhangs and uneveness of the design as well as the bearing ierts being too small and cracking the frame.
The original is now fixed to allow for a tight bearing fit but not enough to crack.
I also added a flat veion that is much easier to print with ABS.
Be sure to check out these two color batman symbol caps by xxdanmurphyxx found here:
Note: This takes a standard 608 bearing. If you find the bearings too loose, print at 99% scale as suggested by donaldkwong.
I found the original tricky to print with ABS due to the slight overhangs and uneveness of the design as well as the bearing ierts being too small and cracking the frame.
The original is now fixed to allow for a tight bearing fit but not enough to crack.
I also added a flat veion that is much easier to print with ABS.
Be sure to check out these two color batman symbol caps by xxdanmurphyxx found here:
Note: This takes a standard 608 bearing. If you find the bearings too loose, print at 99% scale as suggested by donaldkwong.
|
共個(gè)文件
壓縮包大小：320KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付