迪威網友f397e6
發布時間：2021/2/15 21:27:00
The BMG is edited only to use 1/8 thread push fitting. I removed the mk3 carriage plates and added a edited tevo x carriage. Also there are two tifferent bottom parts: one for pinda the other one for BL touch. BL touch is x 30mm right from nozzle.
I use the same BMG on my MK3 and works like charm. Thanks for the original creator MarcoZ76.
M3 Bolts and nuts:
M3 square nuts 2 pcs
M3x10 5 pcs
M3x14 4pcs (fan)
m3x50 3 pcs
1 pc
1pc
1pc
2pc MR85ZZ
Shaft 3x32mm – didn′t find one in ali. Only longer so you have to cut them youelf to lenght.
1pc push fit connector – I used the metal on and made the hole correct on top for the push fitting. 4mm 1/8 thread fitting. Like this.
Optional if you use (and know how to) filament seor:
You can find the itructio for both parts Extruder and Carriage on their original pages:
I use the same BMG on my MK3 and works like charm. Thanks for the original creator MarcoZ76.
M3 Bolts and nuts:
M3 square nuts 2 pcs
M3x10 5 pcs
M3x14 4pcs (fan)
m3x50 3 pcs
1 pc
1pc
1pc
2pc MR85ZZ
Shaft 3x32mm – didn′t find one in ali. Only longer so you have to cut them youelf to lenght.
1pc push fit connector – I used the metal on and made the hole correct on top for the push fitting. 4mm 1/8 thread fitting. Like this.
Optional if you use (and know how to) filament seor:
You can find the itructio for both parts Extruder and Carriage on their original pages:
|
共個文件
壓縮包大?。?MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付