迪威網(wǎng)友be24b7
發(fā)布時(shí)間：2020/10/17 23:57:00
This is a self-made sheath based on Mylez_'s Lambent Light design (
It stops just after the decorative tabs on the blade. It is fairly well toleranced for a stock Ender 5, so anything more precise should have no problem fitting it in. The original model is available in STEP and Solidworks files if modificatio are needed.
Also available are four splits of the sheath while cut in half to fit almost any common printer vertically. Print two of each, and Sheath D needs to have one of its halves mirrored. No supports required.
It stops just after the decorative tabs on the blade. It is fairly well toleranced for a stock Ender 5, so anything more precise should have no problem fitting it in. The original model is available in STEP and Solidworks files if modificatio are needed.
Also available are four splits of the sheath while cut in half to fit almost any common printer vertically. Print two of each, and Sheath D needs to have one of its halves mirrored. No supports required.
|
共個(gè)文件
壓縮包大?。?MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付