迪威網(wǎng)友112ff8
發(fā)布時(shí)間：2020/4/25 4:56:00
This is a 3d-printable shell I'm working on for my working Tricorder that I've been designing for the past couple yea.
Project details here:
The main body part comes in 2 variants, one with a space for a magnetic reed switch (it would be triggered by a magnet in the door assy), and one without.
The door's control panel is designed to allow very thin wire to be run into and glued down, then connected to a capacitive controller.
The main body allows a mainboard 70x80mm.
Parts needed -
2x Hinges (3/4" x 1" Butt Hinge, Black
Item #44445, , They have blackened ones in-store)
10x m2 10mm buttoncap screws (I used Torx t-6 for this)
2x m2 15mm socket head screws (same Torx t-6)
8x small nylon washe
8x 2mm nut
Included is the 123dx file if anyone wants to make any changes, just let me know!
Project details here:
The main body part comes in 2 variants, one with a space for a magnetic reed switch (it would be triggered by a magnet in the door assy), and one without.
The door's control panel is designed to allow very thin wire to be run into and glued down, then connected to a capacitive controller.
The main body allows a mainboard 70x80mm.
Parts needed -
2x Hinges (3/4" x 1" Butt Hinge, Black
Item #44445, , They have blackened ones in-store)
10x m2 10mm buttoncap screws (I used Torx t-6 for this)
2x m2 15mm socket head screws (same Torx t-6)
8x small nylon washe
8x 2mm nut
Included is the 123dx file if anyone wants to make any changes, just let me know!
|
共個(gè)文件
壓縮包大?。?MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付