GoPrint resin test model（高普達樹脂測試模型）

GOPRINT test model explanation

Note: If the column is not straight, there is the following possibilities
1 / screw is not straight, there is a misplaced position
2 / cleaning problem
3 / Iufficient exposure, soft resin, rising deformation


Measuring the diameter of this row, refer to resin precision
If the size is small, it can be increased
If the size is large, it can be reduced.


If the vertical face is not circled, then adjust the lift speed.


Situation 1: Machine Z screw polarization value is not allowed, or the platform is uneven
Situation 2: Upper speed / lack of exposure, leading to the formation of Kongle


If there is no appearance of small characte, it is iufficient


Measuring film adhesion


The paramete of the actual model are preferably blocked by these two holes.


This row special test stacked, but if the cleaning is not in place, it will also be bonded

This has a row of detail small pits special test resin precision
GoPrint測試模型解說

注: 如柱子出現不直情況,有以下可能性
1/絲桿不直,出現錯位
2/ 清洗時碰歪了
3/暴光不足,樹脂偏軟,拉升變形


測量這排柱子的直徑可參考樹脂精度
如發現尺寸偏小, 可加層暴光
如發現尺寸偏大, 可減層暴光


假如垂直面孔不圓， 那就要調整抬升速度.


情況1: 機器Z絲桿步進值不準,或平臺不平
情況2: 升速過快/暴光不足，導致孔拉變形


小字如果沒有出現，那就是暴光不足


測膜粘力


打?qū)嶋H模型的參數最好是這兩個孔堵塞了


這排專測堆料,但假如清洗不到位,也會粘牢

這有一排細節小坑專測樹脂精度